PRODUCT GUIDE
Keypad | Basic & Advanced
5
094361
28643
139567
8112548
5379
6924
Express Register User Credentials and Manager Keys
Make sure the lock is set for assigned use functionality (a green LED will flash when
=
is pressed). The Programming Key can quickly
program multiple locks to operate with the same user credentials and Manager Keys.
Go to a lock already
programmed to operate
with the user credentials and
Manager Keys.
Press
= ` 66 `
. The
LED will turn on.
Insert the Programming Key.
A two-tone beep will be heard
and the LED will turn off.
Insert the Programming Key to
program each lock to operate
with the same user credentials
and Manager Keys.
Two sets of two-tone beeps will
be heard and the LED will flash
twice to indicate successful
programming.
End express registration mode.*
Go to any programmed lock,
press
= `
, then insert the
Programming Key.
Press
= `
, then insert the
Programming Key again to
return the bolt to the original
position.
*The Programming Key will continue to function in express registration mode until it is used to operate a lock.
Make sure the lock is in assigned use functionality (a green LED will flash when
=
is pressed). The locks must be reprogrammed to
remove user credentials from operating a lock.
Remove User Credentials
Collect all remaining and replacement user credentials
(User Codes and User Keys).
Press
= ` 55 `
.
The LED will turn on.
Insert a valid Manager Key.
A two-tone beep will be heard.
Insert the Manager Key again.
Three sets of two-tone beeps will be heard
and the LED will turn off.
All previously assigned user credentials
will be removed.
Follow Assign User Credentials
instructions to assign the remaining and
replacement user credentials.
3
1 2
4
1
3 4 5
2
PROGRAMMING INSTRUCTIONS - IN ASSIGNED USE FUNCTIONALITY
To Next Page
Loading...
