Produ
ct Guide
Keypad
Shared & Assigned Use Functionality
4
Programming Instructions
Set Lock Functionality
Each lock can be set for either shared or assigned use functionality. Press = to check functionality. If in shared use, LED is red. If in
assigned use, LED is green.
To set for assigned use:
Press =` 65 `.
The red LED will turn on.
Insert the Programming Key.
A two-tone beep will be heard
and the green LED will fl ash once.
1122
1
1a
1b
2
2a 2b
Replace Keys
The locks must be reprogrammed to prevent the lost/stolen keys from operating a lock.
To replace the Programming Key:
Note the order or serial number (found on the lock’s rear unit).
Contact Digilock Support to purchase a replacement Programming Key.
To replace the Manager Keys:
Collect all remaining and replacement Manager Keys.
Go to any lock operated by the lost/stolen Manager Keys.
Press
=` 55 `
.
The LED will turn on.
I
nsert the Programming Key.
A two-tone beep will be heard.
Insert the Programming Key again.
Three sets of two-tone beeps will be heard and the LED will turn off. All
previously programmed Manager Keys will be erased.
Follow instructions to Add Manager Keys to program the remaining and
replacement Manager Keys to the locks.
To set for shared use:
Press =` 56 `.
The green LED will turn on.
Insert the Programming Key.
A two-tone beep will be heard
and the red LED will fl ash once.
To Next Page
Loading...
