Digital Check ReceiptNOWTM Elite User Manual
- 9 -
4.2 Printer Installation
1) Printer should be installed on a flat surface.
2) Printer should be kept away from water.
3) Avoid placing printer in a location that would subject it to vibration or impact.
4) The printer should only be plugged into an electrical outlet that has a safety ground.
5) Allow the proper clearance for printer operation and maintenance. Please see picture below showing
the printer open, and ensure adequate clearance.
6) Follow the Instructions on the Read Me First! document to complete the installation and to print
sample receipts. For more detailed installation instructions and to
print a test configuration printout, proceed with the next
Installation section.
4.3 Printer Power Connection
1) Make sure that the printer power switch is turned off.
2) Connect power plug into power socket behind the printer.
Attention
：
If the printer is not to be used for an extended period, unplug the power cord..
4.4 Connecting Interface Cable
1) Make sure printer power switch is turned off.
2) Plug USB cable into the USB socket on the printer.
3) Connect the other end of cable to the computer.
4.5 Paper Roll Installation and Print Check
4.5.1 Check Printing Paper
Paper may be installed while the power and interface cables are connected. Please check paper type
To Next Page
Loading...
Need help?
General