12、SJR
SJR controls the jogging of the machine. Click FRO till SJR is highlighted.
First Option: MODE
Check window 18 and you can see what Jog Mode you are in. By clicking MODE you can change Jogging
to Continuous, Step or to MPG, Window 18 will display this function.
When in Cont Mode, A+ and A- can adjust the speed in 10% increments
When in Step Mode, A+ and A- can change from 0.01mm to 0.1mm to 1mm and to 10mm
When in MPG mode you can use the MPG to jog the machine
Second Option: Jog a defined distance
13、SRO
SRO controls the Spindle Speed. Click FRO till SRO is highlighted, use A+ and A_to adjust the Spindle
Speed in 10% increments
14、FRO
FRO controls the Feed Speed. Click FRO till FRO is highlighted. Use A+ and A- to adjust the Feed Speed
in 10% increments
15、Working time
This column shows the processing time of the G code operation. Time keeping is halted during Pause
16、Processing file
This column shows the name of the processing files. In the formal situation, it only shows the filename.
Under the situation of CONT adjust, it will also show the content of the file.
17、Operating Status
This column shows the operating state. The status and implications can be displayed as follows:
Busy: Operation is running
Reset: Reset flashing = controller not active. To activate the controller click Reset
READY: Ready state. Controller is ready and all operations can be performed
18、Feed status
This window shows the feed status of Jogging and File Processing.
AUTO: displayed while processing and executing the G code file
CONT: indicates Jog CONTINUOUS. You can Jog manually with the “-”or “+” keys of X Y Z and A. A
short click will move the axis in the defined step, a long click will move the axis till you let go
Step: Jogging in Step Mode
Page -17Digtital Dream 4 Axis Motion Controller DDCS V2.1 User’s Manual
To Next Page
Loading...
