Digital Dream DDCS V2.1 - Definition of Keys

The picture 3-4 shows the key layout of the DDCS V2.1. The Controller DDCS V2.1 has 17 keys. Please
see table 3-1 for reference.
Picture 3-4 Keys Layout
3.2 Definition of Keys
Keys Icon Function No. Definition Notes
3. Parameter Value
The Parameter Value column lists the value of each Parameter. This value can be configured
4. Parameter Unit
The Parameter Unit lists the unit of each parameter.
1
1
Start operation
After loading the G code file, please press this key
to start the operation. In case of Pause Status,
press this key to continue the processing operation.
Pause operation Press this key to Pause the operation.
1 Reset and E-STOP
If Reset is blinking, press this key to activate the
controller. Press this key to stop processing urgently.
1 Page switch
Toolpath display switch
Switch through File Management Page, Processing
Main Page and Parameter Configuration Page.
1
Switch the display between Coordinate Display or
Tool Path Tracking display.
1 Spindle manual start/close
Press this key to manually switch the spindle on or
off. Can not be used if Reset is blinking and while
processing an operation (Busy)
Page -19Digtital Dream 4 Axis Motion Controller DDCS V2.1 User’s Manual