[16]
The Spot Monitoring Module shows the channel’s current status based on the settings in the DVR or
NVR.
Icons at the right-upper corner on each
channel screen
Icons at the right-bottom corner on fullscreen
Continuous Recording
No HDD detected
Motion Detection Recording
Emergency Recording is in use
Sensor Activated Recording
PTZ is enabled
Continuous + Motion Alarm
Recording
Warning for exceeding the set
temperature
Continuous + Sensor Activated
Recording
Sequence mode is enabled
Motion Detection + Sensor
Activated Recording
Digital zoom is enabled
Sensor Activated
Motion Detected
Audio Channel
PTZ Camera
If you cannot find any recording icon in the right corner of the screen, then the system is not
recording. Check the recording schedule or camera in the main setup menu.
Users can click the right button of the mouse to pop up sub-menu as below. If the user wants to
control a specific channel, put the mouse cursor on that channel and then click the right button.
Users can change the screen display mode from the available split options.
View the next channel or next group of cameras in the current split
mode.
When “SEQUENCE” is selected, icon will appear on the right-
bottom corner of the screen. The display screen will be sequentially
changed.
• Digital Zoom is available in a single-channel view only. When
“ZOOM” is selected, icon will appear on the bottom-right
corner of the screen and digital zoom control is available.
• To zoom in, drag the mouse’s cursor on the desired area to create
a zoom box. You can also control zoom-in and zoom-out by mouse scrolling the mouse’s
wheel up and down. Once the image is zoomed-in, the user can move the zoom area by
clicking on the edge of the square and dragging it.
To Next Page
Loading...