23 | Chapter 1 : DVR User’s Manual
The user can also select the [PRESET], [GUARD TOUR], or [EXIT PTZ CONTROL].
User can automatically switch PTZ camera positions to the defined preset settings by using [GUARD TOUR] function. The connected
PTZ camera must support touring functions. [GUARD TOUR] on the pop-up menu is only enabled when the PTZ camera channel is
changed to full screen. Please make sure that PTZ camera setting is correct; otherwise, [GUARD TOUR] is shown as disabled.
User will see numeric pad to select Preset number. The preset is defined by setting a PTZ protocol in the setting menu.
The maximum number of preset is 255, but the max supported by the PTZ may be less.
Depending on PTZ camera, some preset positions might be skipped if, for example, the PTZ camera cannot move
mechanically or control focus within the interval time required by the DVR. In this case, it is recommended to increase
the interval setting to a value that allows cameras to finish its Pan & Tilt.
To Next Page
Loading...
