37 | Chapter 1 : DVR User’s Manual
3.1 System
3.1.1 System Info
Click [SYSTEM INFO] to edit the Date, Time, VGA Resolution, Language, Remote ID, Keyboard ID, Baudrate, NTP, Display, and the
Screen Saver. User can also upgrade the Firmware or view the Firmware Version, Video Signal, IP Address, and Mac Address.
Mac address is a unique network identification number for each system.
NTSC/PAL is automatic. Make sure the cameras are connected to the DVR before turning the power on of the DVR.
Remote ID:
The Remote ID should match the ID of the IR Remote Controller in order for the remote to function.
Keyboard ID:
The Keyboard ID should match the selected DVR on the keyboard. In addition, the baud rate and Keyboard should
match the selected keyboard controller.
There are two types of TIME SYNC MODE.
1) Server Mode
The operating DVR is set as a Time Sync Server, which can synchronize the time clock of another DVR(s) connected
over the same network environment.
2) Client Mode
The operating DVR is set as one of the client DVR(s). Input the IP Number of designated DVR, Advanced Client
Software (ACS), or Central Management System (CMS), as a Time Sync Server in [SYNC SERVER]; and then its time
clock is synchronized with Time Sync Server by the setup time in [SYNC CYCLE].
To Next Page
Loading...
