User Manual | 10
1.4.1 Directional Arrows:
1) Live Display & Playback Mode
Change channel number by using Left & Right Arrow buttons.
Change display mode by using up & down Arrow buttons.
2) Menu Setup
Use to select function at the menu setup display.
3) PTZ control (When PTZ button is pressed)
4) Zoom & Focus Mode (when PTZ button is pressed again)
Zoom in & Out by using Up & Down Arrow buttons.
Focus In & Out by using Left & Right Arrow buttons.
5) Call Monitor Mode (When call monitor is selected)
change the camera display in the full screen mode of spot monitor by using the Up & Down Arrow buttons.
1.4.2 ENTER Button
Select value or settings.
1.4.3 Menu /EXIT Button
Toggles On or Off the Menu Setup
1.4.4 MODE (Press Once) / FREEZE (Press and Hold) Button
Change camera display mode 1-8 or 1-16 and
Press and hold to Pause live video display.
1.4.5 PTZ (Press Once) / I-BACKUP (Press and Hold) Button
[PTZ] (Press Once): Press once to change to Pan & Tilt Mode. Use the [Directional Arrows] button to control Pan & Tilt function.
Press [PTZ] button again to change to Zoom & Focus Mode. Use the [Directional Arrows] button to adjust Zoom & Focus.
I-BACK UP (Press and Hold): To start Instant Backup Mode to a USB flash drive
1.4.6 INSTANT REC (Press Once) Button
INSTANT REC (Press Once): To start Emergency Recording Mode
1.4.7 B-MARK (Press Once) / CALL MON (Press and Hold) Button
B-MARK (Press Once): For bookmark recorded video
Press and Hold to activate the Call Monitor function:
Used to display a full screen video of a selected spot out channel. During Call Monitor Mode, click [CLOSE] button at the
bottom of the numeric panel to return to the previously programmed spot out mode.
To Next Page
Loading...
