13 | Chapter 1 : DVR User Manual
1.5.4 Video-Out
To connect Main composite monitor
1.5.5 Spot-Out
To connect composite Spot Monitor
1.5.6 RS-232 Port
RS-232 Input Device (POS)
1.5.7 USB Port (Version 2.0)
1) To backup recorded video, using a USB flash drive (USB Memory Stick or USB HDD)
2) To upgrade the firmware
3) To connect a mouse for system navigation
1.5.8 VGA-Port
To connect a VGA Monitor
1.5.9 LAN Port
To connect RJ-45 jack for Ethernet connection
Consult network administrator or the internet service provider for proper network setting.
1.5.10 Power Input
After connecting peripheral devices such as cameras, monitors, and a mouse to the DVR, connect the 12vDC power supply to
the power jack on the rear panel of the DVR.
1.5.11 Sensor Terminal Block
Connect sensors.
1.5.12 Alarm Terminal Block
Connect various alarm devices controlled by relay output.
1.5.13 RS-485 Terminal Block
Connect RS-485 cable for the control of PTZ camera or external keyboard controller.
NOTE
Use of audio output with an amplifier is recommended!
NOTE
Support both N/O (Normal Open) and N/C (Normal Close) type of sensors. If connected sensor is not functioning, ensure
To Next Page
Loading...
