17 | Chapter 1 : DVR User Manual
2.2 Live Display Mode
2.2.1 Channel Selection
After the cameras are connected, the real-time display mode is controlled through an easy button operation.
The images can be seen on real-time by 1, 4, and PIP screen. Press the Up & down Arrow buttons on the front panel or IR
remote controller to change the display screen sequentially.
[1 Channel] [4 Channel]
[9 Channel] [16 Channel]
[PIP Mode]
To select a channel by mouse, place the cursor on the desired channel and click the left mouse button. To return to previous
screen mode, click the left mouse button again.
NOTE
To select a channel using the mouse, the user is required to perform a slow and clear click of the left mouse button.
To Next Page
Loading...
