DigiTech BASS SYNTH WAH User Manual

7. Pedal Release Pins
These two pins are spring-loaded hinges that hold the pedal in place.
Push these pins in to release the pedal from the pedal chassis
exposing the battery compartment. (See battery replacement
diagram.)
8. Pedal
Press the pedal to turn the effect on and off.
9. Out 1 Normal (Dry) Jack
Use this output when only one amplifier or mixer channel is used.
When both Out 1 Normal (Dry) and Out 2 (Effect) are
connected, only dry, unprocessed bass signal is present at Out 1
Normal (Dry) when the Bass Synth Wah is on or bypassed.

DigiTech BASS SYNTH WAH Specifications

Power

power supply	9V Alkaline Dry Battery
power consumption	4.8 Watts
optional power supply	PS200R - 100 (100V ~ 50/60Hz), 120 (120V ~ 60Hz), 230 (230V ~ 50Hz), 240 (240V ~ 50Hz)

Electrical Specifications

input impedance	1 MOhms
output impedance	100 Ohms
battery life	Approximately 4 hours (with continuous usage)

Weight and Dimensions

dimensions	4 15/16” (L) x 3 1/8” (W) x 2 1/8” (H)
weight	1.38 lbs