Applying Power
There are two options for powering the BP80:battery power, and the included PS200R DC
power supply. Before applying power to anything,set your amp(s) to a clean tone and set the
tone controls to a flat EQ response (on most amps,this would be 0 or 5 on the tone controls).
Battery Power
The BP80 can be run for more than 15 hours on 6 AA batteries.The battery compartment
is located on the bottom of the BP80. The following diagram shows how to install the
batteries.
Note: Pay close attention to the battery polarity when installing batteries as
polarity changes direction for each pair.
8
To Next Page
Loading...
