Connecting an instrument cable to the Input applies power to the BP80. Disconnecting
your instrument from the Input of the BP80 disconnects the battery power. Turn your
amplifier(s) on and adjust the volume(s) to a normal playing level. To prolong the battery
life, disconnect your instrument from the BP80’s Input when it is not in use .
AC Power
The BP80 can also be powered with the included PS200R power supply. Connect the plug
of the PS200R power supply to the power jack on the rear panel of the BP80. Connect the
other end of the PS200R power supply to an AC outlet. Turn your amplifier(s) on and
adjust the volume(s)to a normal playing level.
About the BP80
The Presets
Presets are numbered locations of programmed sounds. Presets are recalled with the
Footswitches. The BP80 comes with 40 User Presets (Presets 1-40) and 40 Factory Presets
(Presets 41-80). The User Presets are locations where you can store presets. The Factory
Presets may not be saved over. From the factory, the 40 User Presets are exact duplicates
of the 40 Factory Presets.
9
To Next Page
Loading...
Need help?
General
