1. Footswitches - These 2 Footswitches are used to select presets, access the Tuner, or bypass
the BP80. The Up Footswitch increments,and the Down Footswitch
decrements through the presets. Pressing both Footswitches simultaneously
bypasses the selected preset. Pressing and holding both Footswitches
accesses the Tuner.
2.Value/Volume Buttons - The Value Buttons perform various value adjustment functions for
the BP80. These buttons are used to control the BP80’s Master
Level,adjust a selected effect,and also change the Pattern,Tempo,
and Level of the Drum machine when it is turned on. When the
Tuner is enabled, these buttons select the tuning reference.
3. Edit/Effect Buttons - Pressing either of the Edit/Effect buttons enters Edit mode and selects
the individual effects to be edited.Press the left and right Edit buttons
to move through the effects. Each effect LED will light to indicate
which effect you are editing
4. Drums - The Drums button is used to turn on and off the BP80’s drum machine. When the
Drums are active,the Drums LED lights and the selected drum pattern plays
continuously.
5. Effect LEDs - The Effect LEDs show which effects are active in the current preset. In Edit
mode,the LEDs indicate the effect selected for editing. In Tuner mode,the
LEDs indicate whether the note played is sharp, flat,or in tune.
3
To Next Page
Need help?
General
