To Next Page

To Previous Page

Operation

The JamMan Express XT was designed to be very simple to use right out of the box� This

section of the manual describes how to perform the basic looping functions�

Recording a Phrase

The JamMan Express XT records a single phrase and then plays it back as a continuous loop�

To record a phrase:

1� Press the

FOOTSWITCH and begin playing to start recording� The REC LED will light

solid red and recording will begin�

2� When ﬁnished recording, press the

FOOTSWITCH once to set the loop end point� The

phrase will automatically begin playing back in a repeating loop and the

PLAY LED will

light solid green�

3� Press the

FOOTSWITCH 2 times quickly to stop loop playback�

NOTE: The maximum phrase recording length is 10 minutes�

Clearing a Phrase

Clear a phrase to re-record it or record a new phrase� The JamMan Express XT has a

unique feature, referred to as "Silent Clear

™

", which clears a phrase without requiring you

to play it ﬁrst� Note that you cannot undo the process of clearing a phrase, so make sure

you want to proceed before performing this function�

To clear a recorded phrase:

1� Stop loop playback if it is not already (all LEDs should be off)� If loop playback is active

(the

PLAY LED is on), press the FOOTSWITCH 2 times to stop loop playback�

2� Press and hold the

FOOTSWITCH for ~2 seconds� The REC LED will quickly ﬂash red,

indicating the phrase has been cleared�

NOTE: When using a slave/master looper setup, if the master loop is ~3 seconds or less

and if pressing and holding the

FOOTSWITCH from a stopped state does not initiate

clear on the slave device, you may need to initiate play then stop (3

FOOTSWITCH

presses) and hold the footswitch on the 3rd press to clear its loop�

DigiTech JamMan Express XT User Manual

Questions and Answers: