DigiTech JamMan Solo User Manual

12
The JamMan
®
Solo has two banks of loop
memory, internal and optional external
card memory. There are 99 memory
locations available in each of these banks
for a total of 198 memories when an
optional SD/SDHC memory card is
installed. The external memory bank is
only available when a memory card is
installed.
NOTE: Changing loops discards any
changes that have not been stored to
memory. Storing the changes will remove
the ability to undo or clear overdubs.
To select loops, press either of the LOOP
SELECT buttons. Pressing the up arrow
button will select the next loop above the
current loop. Pressing the down arrow
button will select the previous loop below.
The DISPLAY will show the memory
location number as these buttons are
pressed.
When Loop 99 is reached, pressing
the up arrow button will return to
the first memory location (1 will be
shown in the DISPLAY). Likewise, if
Loop 1 is reached, pressing the down
arrow button will return to the last
memory location (99 will be shown in
the DISPLAY). If an optional memory
card is installed, pressing the LOOP
SELECT buttons will alternate through
one bank of memories and then the next
(1-99 internal and then 1-99 external).
The CARD MEM LED will light when
memories are selected on the optional
external card.
Select a Memory Location

DigiTech JamMan Solo Specifications

General

Brand	DigiTech
Model	JamMan Solo
Category	Music Pedal
Language	English