14
Refer to page 26 to enable the Pedal
Tempo feature on the JamMan
®
Solo.
Select an empty memory location 1.
using the LOOP SELECT buttons
(the LOOP and SINGLE LEDs will
be off).
Tap the 2. PEDAL SWITCH at the
tempo you want to play. Adjust
the RHYTHM LEVEL knob to a
suitable volume. The TEMPO button
will now be flashing at the set tempo.
The first downbeat of the measure
flashes red and the other beats flash
green. Once you have the tempo set,
you must press and hold the PEDAL
SWITCH for two seconds to fix
the tempo (The TEMPO button will
flash yellow and the PDL TEMPO
LED will flash and then turn off).
Press the 3. PEDAL SWITCH again
and there will be a single measure
count-in indicated by the flashing
TEMPO button and STATUS
LED before recording begins. The
STATUS LED will then light solid red
and recording will start.
When you are finished recording, 4.
press the PEDAL SWITCH once
to set the loop point and have the
phrase play back in a repeating
loop. Press the PEDAL SWITCH
two times quickly to stop the loop
playback.
Create a Loop, with Tempo Count-in (PDL TEMPO LED is on)
To Next Page
Loading...
Need help?
General
