47
RP360 / RP360 XP
USB Play Mix
This system parameter controls the output mix of
the RP processed signal and USB playback signal
(from your computer)� When this parameter is
set to the center of its controllable range, it will
read "USB:RP" – this represents equal mix levels
between the RP signal and USB playback signal� As
you adjust the control counter-clockwise, you can
vary the USB playback level in relation to the RP
Plexi-Drive 1
LOOPER READY
SYSTEM SETTINGS 2/4
USB
RECORD LVL
USB
PLAY MIX
LCD
CONTRAST
0 dB USB:RP
level� As you adjust the control clockwise, you can vary the RP signal level in relation to the USB
playback level� This parameter is only available when a USB connection has been made to the RP�
To edit the USB PLAY MIX parameter:
1�
Connect the RP to your computer using a standard USB cable�
2� Press the SYSTEM button�
3� Press either the SELECT knob or SYSTEM button repeatedly until the LCD display reads 2/4 in
the upper right-hand corner of the LCD display�
4� Turn the EDIT 2 (USB PLAY MIX) knob to adjust the setting�
5� Press the BACK button or any FOOTSWITCH to exit the System Settings menu and return to
the Performance state�
To Next Page
Loading...
Need help?
General
