Digitus DA-81002 - 1. Operating Setting; 1.1 Use of the setting code; 1.2 Factory Default Reset; 1.3 User default settings

2
1. Operating Setting
The factory default settings of DA-81002 can meet the needs of users for direct use in most cases.
You can also set the parameters through the setting code according to actual needs.
1.1 Use of the setting code
Read the "Enable Setting Code" to configure the function of the reading module (setting code
function). After the function is turned on, you can modify the parameters of the reader module by
reading one or more setting codes. After reading the "Close Setting Code", the scanning module will
exit the setting state.
**Enable Setting Code
Close Setting Code
Set the code content output enable and disable.
Output setting
code content
**Do not output the content of the setting code
Note: The options marked with (**) in the setting code indicate the default functions or
parameters.
1.2 Factory Default Reset
After reading this setting code, the current parameter setting will be lost and the factory default
value will be restored. The factory default parameters and functions can be found in Appendix C.
Restore Factory Default
Note: Please use the "Restore Factory Default" function with caution.
1.3 User default settings
In addition to restoring factory settings, users can save frequently used settings as user default
settings. By reading "Save current settings as user default settings", the current device configuration
can be saved as user default information for quick settings when needed.