147
9.4 Modify Setting Values – “set” Command
“set” command is used to modify the setting values of
this print server. The format of “set” command is as
following:
set argument_name value
Then the value will be written into the system
configuration. For example, if you want to set IP address of
the print server to 192.168.2.2, type “set ip 192.168.2.2”
command and the IP of the print server will be changed.
After the setting is finished, please reboot the print server.
admin# set ip 192.168.2.2
admin# reboot
If you enter only “set”, the system will list all
arguments of “set” command and the command format.
The following table lists all the arguments whose value
can be modified by “set” command:
Argumen
Description Example
psname
Print server name set psname PS001
password
Login password set password 1234
username
Login username set username admin
wlfunc
Enable or disable the
wireless LAN function.
The value should be
“disabled”, “enabled” or
“auto”
set wlfunc auto
wlmode
Wireless LAN mode is
Infrastructure.
The value should be “inf”
set wlmode infrastructure
ESSID
ESSID of the wireless LAN set ESSID default
To Next Page
Loading...
Need help?
General
