77
Click the “IP” button to enter the IP setting page. If
you need the print server to automatically get an IP from
DHCP server, select “Auto IP”. You also can select “Static
IP” to manually assign “IP Address”, “Subnet Mask” and
“Gateway” for the print server.
Click the “DHCP Server” button to enter the DHCP
server’s setting page. You can “Enable/Disable” the DHCP
server or set “Auto” and assign a range of IP addresses here.
The DHCP server is disabled by default. If Auto is selected,
the DHCP Server of print server will be enabled only when
there is no other DHCP Server within the network. When
“Enable” or “Auto” is selected, you have to configure
“Starting Address”, “Range”, “Subnet Mask”, “Gateway”
and “DNS”. The print server will assign a unique IP for
each client.
To Next Page
Loading...
Need help?
General
