12
6.4 Plugging in the AC Power Cord
You can connect AC power supply cord to switch back and the other
side connect the power outlet. (Power outlet might as well grounding
and support over voltage protection).
Warning: Do not turn on the power switch before power cables are
connected. Power surge may cause damage to the Switch.
6.5 Power failure
As a precaution, the switch should be unplugged in case of power
failure. When power is resumed, plug the switch back in.
Please be aware of following safety Instructions when installing:
A) Elevated Operating Ambient - If installed in a closed or multi-unit
rack assembly, the operating ambient temperature of the rack
environment may be greater than room ambient. Therefore,
consideration should be given to installing the equipment in an
environment compatible with the maximum ambient
temperature (Tma) specified by the manufacturer.
B) Reduced Air Flow - Installation of the equipment in a rack should
be such that the amount of air flow required for safe operation of
the equipment is not compromised.
To Next Page
Loading...
