FAQ
TV display “Waiting for connection” on the right corner?
A: Please check if the power supply of TX (Sender) and switcher (If
used) is connected, and make sure connecting cable is firmly.
TV display “Please check the TX input signal”?
1) Please check if there is a HDMI signal input of TX.
2) Try to connect the signal source directly to display device to see
if there is signal output from source device or change the signal
source, HDMI wire and try again.
When playing 4Kx2K source, screen is back without any content?
Make sure both TV and HDMI cable support HDMI 1.4
Display not fluent, not stable?
A: 1) Please check the cable length between the TX to switch, the
switch to the RX and the connection between each level is
within the required range.
2) Click the “reset” button on the TX/RX front panel, reset and
This is a Class A product. In home environment, this product may cause radio interference.
In this case, the user may be required to take appropriate measures.
Hereby Assmann Electronic GmbH, declares that the Declaration of Conformity is part of
the shipping content. If the Declaration of Conformity is missing, you can request it by post
under the below mentioned manufacturer address.
www.assmann.com
Assmann Electronic GmbH
To Previous Page
Loading...
Need help?
General
