FAQ
Q: There is no output on screen when all connections are correct?
A:
1. Please check and make sure the display/monitor supports the HDMI signal
which fed out from the source device.
2. Please make sure the HDMI cables supports 4K×2K if the output signal from
the source device is 4K×2K resolution.
3. Please check and make sure the network cable insert to the RJ45 port well.
4. Restart the transmitter or receiver by pressing the reset button.
Q: Black screen happened on the display/monitor?
A:
1 Please check and make sure the length of the network cable within the usable
range:
CAT 6 within 60m@4K×2K@30Hz,
CAT 6 within 30m@4K×2K@60Hz
2 Reset the transmitter unit for re-built the connection
Q: The color becomes abnormity, or there is no audio output?
A:
Reset the transmitter unit for re-built the connection
Herby Assmann Electronic GmbH, declares that the Declaration of Conformity is part of the
shipping content.
If the Declaration of Conformity is missing, you can request it by post under the below
mentioned manufacturer address.
www.assmann.com
Assmann Electronic GmbH
Auf dem Schüffel 3
58513 Lüdenscheid
Germany
To Previous Page
Loading...
Need help?
General
