Digitus DS-55318 User Manual

9
Transmitter Installation
• Connect the Transmitter Unit HDMI to PC HDMI port
Remark: if the source devices HDMI with 5V power output, then no
need connect USB cable for power, if not, please connect the
Transmitter Unit with PC by USB cable for power. To have a safe and
stable operation, we recommend to use always the Micro USB cable
for power supply of TX and RX
• The LED indicator of the Transmitter Unit will turn red when it’s
booting up
• The LED indicator will become constant blue when the
Transmitter Unit and Receiver Unit connected
8. Pairing Transmitter and Receiver
A set of the Wireless HDMI Extender Set includes one receiver and
one transmitter, which are paired before shipment. Normally you
don’t need to pair them again thanks to auto-pair feature.
However, if you need to re-pair, you need to follow the instruction
below to pair the transmitter with the receiver:
1. Power on receiver and connect with display
2. Power on the transmitter till the LED turn to flashing red, then
press the button up to 5 seconds till the LED become fast
flashing red, this means the transmitter unit is in factory reset
mode.
3. Wait around 15 seconds, the button light of Transmitter Unit will
turn to constant blue from the red light, and the pair successful
message will be displayed on the Receiver Unit screen.

Digitus DS-55318 Specifications

General

Brand	Digitus
Model	DS-55318
Category	Extender
Language	English