Dillon AP - Separation of Pressure Bar and Gauge Movement on 10 Diameter Units up to 20,000 lb;10000 kg; Reassembly of Pressure Bar and Gauge Movement on 10 Diameter Units up to 20,000 lb;10000 kg

Dynamometer Installation Instructions 5
1.4 Routine maintenance
1.4 Routine maintenance
1.5 1.5 Cleaning the Dynamometer
Cleaning DOs and DON’Ts
l DO - Wipe down the outside of standard products with a clean cloth,
mo
istened with water and a small amount of mild detergent
l DO NOT - Attempt to clean the inside of the machine
l DO NOT - Use harsh abrasives, solvents, scouring cleaners or alkaline
clea
ning solutions
1.6 Training
Do not attempt to operate or complete any procedure on a machine unless you have
received the appropriate training or read the instructions.
IMPORTANT: This equipment must be routinely checked for proper operation and
calibration.


Application and usage will determine the frequency of calibration required for safe
operation.