9
To activate the configuration mode from normal operation, use one hand to
press and hold the F key and use the other hand to press the TEST key.
Return to normal operations by using one hand to press and hold the F key
and use the other hand to press the CLR/ZERO key.
Upon entering configuration mode, the selected unit annunciator will flash
(indicating that the device is out of the normal operating mode) and the
display will show the current value for setpoint 1.
The configuration values may be changed and permanently stored in nonvola-
tile memory within the device. Consequently, use these functions with care.
Note that the values will be changed immediately in the EEPROM, but some
changes will only take effect when the unit is switched off and then back on.
These values are noted with an asterisk in the "Label" column of Table 5
Table 4 shows the keys you use to set configuration to your needs. Table 5
contains the configuration items you can view and change.
Table 5 contains the information fields and typical values you can view in the
configuration mode. The fields appear in the sequence shown. Scrolling past
the last item in the list will return the display to the first item in the list.
Configuration Mode
Key Function Display
The "label" for the field is shown briefly
when the key is kept depressed. The
actual information value is then shown.
Same as for PEAK HOLD.
Same as for PEAK HOLD.
Dependent upon function selected.
Dependent upon function selected.
Scroll down in list of information fields, i.e. the
next field in the list.
Scroll up in list of information fields, i.e. the
previous field in the list.
Show the label of the current information field.
Increment the value shown with wraparound.
Decrement the value shown with wraparound.
Return to basic function mode.
PEAK HOLD
TEST
UNITS
F+PEAK HOLD
F+TEST
F+CLR/ZERO
Table 4
Key Functions in Configuration Mode
To Next Page
Loading...
Need help?
General
