Dimension One Spas Spa - Light Bulb and Shell Surface Care

Dimension One Spas – Reflections Owner’s Manual
31
Light Bulb Replacement
Some models are equipped with a standard light bulb, others with an optional “Dynamic L.E.D.
Light,” and others with a Soft Touch Lighting System, but all are replaced in the same way. To
change the bulb:
1. Turn the power off at the GFCI breaker and drain the
water to below the level of the light.
2. Using the special tool provided in the owner’s
manual packet, unscrew the lens that covers the
light housing.
3. Remove the old bulb and install the new bulb.
4. Use the special tool to replace the lens on the light
housing.
5. Turn the light on and off to make sure it works before refilling the spa.
Do not attempt to remove the lens without draining the water to below the level of
the light.
Do not attempt to remove the lens without the special tool. If you have lost it,
contact Dimension One Spas Service Department to have one sent.
Be sure the rubber O-ring behind the lens is undamaged and is properly positioned
when replacing the lens. Contact Dimension One Spas if you need a replacement
O-ring.
Surface Care for Ultralife® and Colored Shells
We recommend using a “cheesecloth” rag, or other soft rag, to clean the entire shell surface with
Water Line Cleaner or a similar product from your spa dealer. You may also use ph/Alkalinity
Increaser or a 50/50 solution of denatured alcohol and water. Be sure to thoroughly rinse the shell
after cleaning. To restore the luster of the shell after cleaning, you can use Poli-Gloss or a similar
product from your spa dealer.
Do not use “409” type cleaners or other caustic solutions as they may damage the
shell surface and void the warranty. If you are using baking soda to clean your hot
tub shell, be careful not to get it on the wood skirt. It may bleach the wood.
Do not use citrus-based cleaners on the shell surface.
UColored Shells:U If your spa has a colored shell you must keep the spa covered even
when it contains no water. Sunlight can damage the spa surface and cause it to
peel or blister.