Dimension One Spas Spa - Scrolling Message Center Functions; Setting the Temperature; Filter Maintenance Prompts

Dimension One Spas – Reflections Owner’s Manual
13
Control Panel Functions Unique to the Scrolling Message Center
Messages that Appear in the Scrolling Message Center
If your spa is equipped with the Scrolling Message Center (to confirm this, see that your control
panel has an Enter Button on it), then the spa will automatically provide warnings, prompts, or
reminders to you in the Display Window as described below.
Setting the Temperature
When you press the Up (+) and Down (-) Buttons to set the spa
temperature the words “SET TEMP TO _ _ _ F” appear in the lower
left of the Scrolling Display Window. After you set the target
temperature, the current temperature again appears in the
Display Window while the bottom left corner scrolls the message
“HEATING TO _ _ _ F” until the hot tub reaches the target
temperature. A thermometer icon appears in the top center of
the Display Window while the spa is heating.
If the water reaches 2 F (1 C) above the target temperature,
the message “COOLING TO _ _ _ - CIRC PUMP & O3 OFF” will be
displayed in the bottom left hand side of the Digital Display
Window, and a cooling cycle will start.
Rinse Filters
Every other month, your Scrolling Message center will Display
“RINSE FILTERS.” The bottom of the Display Window will scroll the
following instructions : “REMOVE FILTERS & RINSE WITH HOSE... PUSH
AND HOLD ICON BUTTON MORE THAN 3 SECONDS TO RESET THIS
MESSAGE.”
To reset (turn off) this message, push and hold the Dimension One
Spas ICON (logo) located at the right hand side of the control for
3 seconds.
Clean Filters
On alternate months when “Rinse Filters” does not appear, the
Scrolling Message Center will display “DIRTY FILTER.” The bottom of
the Display Window will scroll the following instructions: “REMOVE
FILTERS & CLEAN IN SOLUTION... PUSH AND HOLD
ICON BUTTON MORE THAN 3 SECONDS TO RESET THIS
MESSAGE”
To reset (turn off) this message, push and hold the Dimension One
Spas ICON (logo) Button located at the right hand side of the
control panel for 3 seconds.
Change Water
Every four months, your Scrolling Message center will Display
“CHANGE WATER.” The bottom of the Display Window will scroll
the following instructions : “TURN POWER OFF, DRAIN & REFILL
SPA...PUSH AND HOLD ICON BUTTON MORE THAN 3 SECONDS TO
RESET THIS MESSAGE.”
To reset (turn off) this message, push and hold the
Dimension One Spas ICON (logo) Button located at
the right hand side of the control panel for 3
seconds.