Dimension One Spas Spa - Troubleshooting Guide; Heating System Issues

Dimension One Spas – Reflections Owner’s Manual
33
For more information about Winterizing your system, or restarting a Winterized system, please
contact your local Authorized Dimension One Spas dealer.
Troubleshooting Guide
Heating System
Symptom Problem Corrective Action
1. Temperature setting is
too low
1. Turn up the “set temperature” on the control panel
2. Dirty filter 2. Clean filter
Does not heat
3. Flow switch
malfunction
3. Call your dealer for service
1. Temperature setting
too high
1. Turn down the “set temperature” on the control panel Too hot
2. High limit tripped 2. Call your dealer for service
Flashing
temperature of
34F (1 C)or
134F (56 C)
appears on the
display
Possible temperature
sensor failure
Call your dealer for service
Hot Tub
Temperature
erratic
Water level Fill hot tub to about six inches below the top of the spa or 1” (2.54 cm)
to 2” (5.08 cm) above the bottom of the tile line if your spa has tile.
1. Too much filtration 1. Reduce the number of filter cycles and/or the filter cycle duration
2. Temperature setting
too high
2. Turn down the “set temperature” on the control panel
Display reads
OVERHEAT
3. High limit or sensor
problem
3. Call your dealer for service