Dimension One Spas Spa - Digital Control Panel Functions; Setting the Temperature

Dimension One Spas – Reflections Owner’s Manual
21
Reset the Control Panel
If needed, you can reset all your hot tub settings to the
factory defaults with one step. Please keep in mind that this
resets not only your programming, but also all maintenance
messages (clean filters, change water, etc.), as if the hot tub
had just been installed. To reset the control panel, push the
following sequence of buttons within 3 seconds:
1. Push the ICON (logo) Button
2. Push the ENTER Button
3. Push the PROGRAM Button
The top line of the Display Window will say: “RESET
PROGRAMMING?”
The bottom line will say: “IF SO, PUSH ICON”
Push the Dimension One ICON Button to reset the entire
control system to factory defaults, or do not push any button
for 10 seconds to exit without resetting.
Control Panel Functions Unique to “Digital Control Panel” Models
Your spa is equipped with either the Scrolling Message Center, OR the Digital Control Panel. (If your
control panel has an Enter button then you have the Scrolling Message Center, and you should see
“Features Unique to Scrolling Message Center Models” for instructions).
The Digital Control Panel
The basic features of your control panel are described in the preceding Operation Section. The
following features and functions are unique to models with the Digital Control Panel.
Setting the Temperature
You control the water temperature by using the Up (+) and
Down (-) Buttons. The SET TEMPERATURE Icon appears in the
lower right side of the Window to indicate that the temperature
shown is a “target setting” and not the actual temperature. The
Temperature Icon will appear at the top of the window if your
new setting requires more heat.
Once the new temperature is set, the Display Window once
again shows the actual spa water temperature. The spa will
heat to the new temperature automatically.