Why is the flame frozen on my Dimplex 6905050100-500?
If the flame is frozen on your Dimplex Indoor Fireplace, it could be due to a defective Flicker Motor, which needs replacement. Another possible cause is loose wiring, so check the wiring connections.
Why is there excessive noise with the heater on in my Dimplex 6905050100-500 Indoor Fireplace?
Excessive noise with the heater on in your Dimplex Indoor Fireplace can be caused by a dirty Heater Assembly. Ensure that the exterior intake louvers and firebox cavity are free of dirt and dust. It could also indicate a defective Heater Assembly, which would need replacement.
Why does the heater fan run continuously on my Dimplex 6905050100-500 Indoor Fireplace?
If the heater fan in your Dimplex Indoor Fireplace runs continuously, it could be due to a defective Heater Switch, a defective Thermostat, or a defective Heater Assembly. In each case, the suggested solution is to replace the defective part.
Why does the heater fan turn on, but my Dimplex 6905050100-500 Indoor Fireplace lacks heat?
If the heater fan in your Dimplex Indoor Fireplace turns on but the heater lacks heat, first check for proper operation. Second, check for loose wiring in the unit. Third, the Thermostat or Heater Assembly may be defective, requiring replacement.
Why does my Dimplex 6905050100-500 Indoor Fireplace heater emit an odor?
If your Dimplex Indoor Fireplace heater emits an odor, it is often normal when the heater is initially turned on, as it burns off dust accumulated during manufacturing or operation. However, it can also indicate a defective Heater Assembly, which would need replacement.
Why does the heater on my Dimplex Indoor Fireplace turn off after a few minutes?
If the heater in your Dimplex Indoor Fireplace turns off after a couple of minutes, it could be due to a buildup of dirt or dust in the Heater Assembly. Ensure that the exterior intake louvers and firebox cavity are free of dirt and dust. It may also indicate a defective Heater Assembly, which would need replacement.
Why is the heater on my Dimplex Indoor Fireplace not turning on?
If the heater in your Dimplex Indoor Fireplace is not turning on, first check for proper operation. Second, check for loose wiring in the unit. Third, the Heater Switch, Thermostat, or Heater Assembly may be defective, requiring replacement.
What causes the heater on my Dimplex Indoor Fireplace to not turn off?
If the heater in your Dimplex Indoor Fireplace is not turning off, this could be due to improper operation. Also, it could be caused by a defective Heater Switch, a defective Thermostat, or a defective Remote Control Receiver. In each case, the suggested solution is to replace the defective part.
Why do lights dim when my Dimplex 6905050100-500 Indoor Fireplace is on?
If the lights dim in the room when your Dimplex Indoor Fireplace is on, it means the unit is drawing close to the circuit's current rating. To resolve this, move the unit to another outlet or install it on a dedicated 15 amp circuit.
What to do if my Dimplex 6905050100-500 does not turn on with the remote control?
If your Dimplex Indoor Fireplace is not turning on with the remote control, first check for proper operation. Second, the Remote Control may not be initialized to the fireplace, so you should initialize it. Third, the Remote Control itself might not be working, so install a new battery and initialize the Remote Control. Finally, check the wiring connections for any loose wiring.
General| Type | Electric Fireplace |
|---|---|
| Model Number | 6905050100-500 |
| Voltage | 120V |
| Wattage | 1500W |
| BTU | 5118 BTU |
| Heating Area | 400 sq ft |
| Flame Effect | Yes |
| Adjustable Thermostat | Yes |
| Remote Control | Yes |
| Overheat Protection | Yes |
To Next Page