EasyManua.ls Logo

Dimplex BF33STP/DXP - User Manual

Dimplex BF33STP/DXP
14 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Owner’s Manual
Model
BF45DXP
BF39STP/DXP
BF33STP/DXP
7206360500R04
IMPORTANT SAFETY INFORMATION: Always read this manual rst
before attempting to install or use this replace. For your safety, always
comply with all warnings and safety instructions contained in this manual
to prevent personal injury or property damage.
To view the full line of Dimplex products, please visit
www.dimplex.com

Table of Contents

Other manuals for Dimplex BF33STP/DXP

Preview: User Guide
User Guide14 pages
Preview: Installation Guide
Installation Guide14 pages

Questions and Answers

  • K
    Kelly BennettSep 18, 2025
    Why is my Dimplex Indoor Fireplace grinding with the heater off?
    • D
      Daniel HooverSep 18, 2025
      If your Dimplex Indoor Fireplace is making grinding or excessive noise with the heater off, the moving flicker rod might be hitting or rubbing against internal components. Make sure the rod is straight and mounted properly in the bracket, spinning freely away from other components. Replace it if necessary. Alternatively, the flicker motor may be defective and need replacement.
  • C
    Courtney FergusonSep 12, 2025
    Why is the power cord getting warm on my Dimplex BF33STP/DXP Indoor Fireplace?
    • S
      shammondSep 12, 2025
      The power cord of your Dimplex Indoor Fireplace may get slightly warm to the touch when the heater is on, which is normal during operation. However, if the cord gets hot to the touch, the power cord may be defective and should be replaced.
  • L
    Lauren Hernandez MDSep 8, 2025
    Why is my Dimplex Indoor Fireplace heater fan on but there is no heat?
    • S
      Samantha GreenSep 8, 2025
      If the heater fan in your Dimplex Indoor Fireplace is running but there is no heat, ensure that you are operating it correctly. Check the wiring in the unit for any looseness. If these steps don't resolve the issue, the Heater Assembly might be defective. Replace the Heater motor if it's not running when heat is activated, or replace the Heater Elements if the motor is running but heat is not coming out.
  • C
    Christine ConwayAug 27, 2025
    What to do if my Dimplex BF33STP/DXP is not turning on manually?
    • A
      alexander81Aug 27, 2025
      If your Dimplex Indoor Fireplace isn't turning on manually, start by making sure you are operating it correctly. Check the fuse/breaker panel to ensure there's incoming voltage from the electrical wall socket. Inspect the wiring connections for any looseness. If these steps don't resolve the issue, the On/Off Switch or the 3-Position Switch might be defective and require replacement.
  • M
    Michael WashingtonAug 27, 2025
    Why is my Dimplex Indoor Fireplace heater turning off after a few minutes?
    • S
      Sharon HuynhAug 27, 2025
      If your Dimplex Indoor Fireplace heater turns off after a couple of minutes, it could be due to a buildup of dirt or dust in the heater assembly; ensure that the exterior intake louvers and firebox cavity are free of dirt and dust. Alternatively, the Heater Assembly might be defective. In this case, replace the Heater motor (if it's not running when heat is activated) or the Heater Elements (if the motor is running but heat isn't coming out).
  • J
    James EllisAug 29, 2025
    What to do if my Dimplex BF33STP/DXP Indoor Fireplace is not turning on with the remote control?
    • R
      randolphstevenAug 29, 2025
      If your Dimplex Indoor Fireplace isn't turning on with the remote control, first, ensure you are operating it correctly. Then, check if the remote control is initialized to the fireplace; if not, initialize it. If it still doesn't work, try installing a new battery into the remote control and reinitializing it. If the problem persists, the Remote Control Receiver Kit might be defective and need replacement.
  • J
    Joshua SimpsonAug 30, 2025
    What to do if my Dimplex Indoor Fireplace is not turning on with the wall mounted remote?
    • P
      Patrick AndersonAug 30, 2025
      If your Dimplex Indoor Fireplace isn't turning on with the wall-mounted remote, start by ensuring proper operation. Then, check if the remote control is initialized to the fireplace and initialize it if necessary. If it still fails, install a new battery into the wall mounted remote control and reinitialize the remote. If the issue continues, the Remote Control Receiver Kit might be defective and require replacement.
  • J
    Joan StewartAug 31, 2025
    Why is my Dimplex BF33STP/DXP heater not turning off?
    • T
      Tommy SmithSep 1, 2025
      If the heater on your Dimplex Indoor Fireplace is not turning off, first, ensure you are operating the unit correctly. If applicable, verify the proper operation of the Thermostat/Wall Controls. If the problem persists, the heater on/off switch or the heater assembly might be defective and require replacement.
  • R
    rileykyleSep 23, 2025
    Why is my Dimplex BF33STP/DXP making excessive noise with the heater on?
    • F
      fmorrisSep 23, 2025
      If your Dimplex Indoor Fireplace is making excessive noise with the heater on, the blower assembly may be dirty; ensure that the exterior intake louvers and firebox cavity are free of dirt and dust. If the noise persists, the heater motor may be defective and need replacement.
  • K
    Kevin WongSep 9, 2025
    Why is my Dimplex BF33STP/DXP log set dim?
    • J
      Jeffrey WatsonSep 9, 2025
      If the log set in your Dimplex Indoor Fireplace is dim and the ember bed is not glowing, this could be due to burnt light bulbs, which need to be replaced.

Dimplex BF33STP/DXP Specifications

General IconGeneral
BrandDimplex
ModelBF33STP/DXP
CategoryIndoor Fireplace
LanguageEnglish

Related product manuals