Why is my Dimplex BF33ST/DX making excessive noise with the heater on?
If your Dimplex Indoor Fireplace is making excessive noise with the heater on, the blower assembly may be dirty; ensure that the exterior intake louvers and firebox cavity are free of dirt and dust. If the noise persists, the heater motor may be defective and need replacement.
What to do if my Dimplex Indoor Fireplace heater is not turning on?
If the heater on your Dimplex Indoor Fireplace isn't turning on, several factors could be responsible. Begin by ensuring proper operation. Also, check for loose wiring within the unit by tracing the wires. Other possible causes include a defective 3-Position Switch or a defective Remote Control Receiver Kit (if applicable), which would need replacing.
Why does my Dimplex BF33ST/DX Indoor Fireplace turn on and off by itself?
Your Dimplex Indoor Fireplace might be turning on and off by itself for several reasons. The remote control may have a similar frequency to other remotes in the area; if so, replace the remote control. If you have a wall-mounted remote, its frequency might be interfering; try changing the RF frequency and reinitializing it. Radio frequency disturbance from outside sources could also be the cause, in which case you should replace the remote control and Remote Control Receiver Kit, where necessary. Finally, a defective Remote Control Receiver Kit could be the culprit, and replacing it may solve the issue.
What to do if my Dimplex BF33ST/DX Indoor Fireplace is not turning on manually?
If your Dimplex Indoor Fireplace isn't turning on manually, start by making sure you are operating it correctly. Check the fuse/breaker panel to ensure there's incoming voltage from the electrical wall socket. Inspect the wiring connections for any looseness. If these steps don't resolve the issue, the On/Off Switch or the 3-Position Switch might be defective and require replacement.
Why is my Dimplex BF33ST/DX Indoor Fireplace heater turning off after a few minutes?
If your Dimplex Indoor Fireplace heater turns off after a couple of minutes, it could be due to a buildup of dirt or dust in the heater assembly; ensure that the exterior intake louvers and firebox cavity are free of dirt and dust. Alternatively, the Heater Assembly might be defective. In this case, replace the Heater motor (if it's not running when heat is activated) or the Heater Elements (if the motor is running but heat isn't coming out).
Why is my Dimplex BF33ST/DX grinding with the heater off?
If your Dimplex Indoor Fireplace is making grinding or excessive noise with the heater off, the moving flicker rod might be hitting or rubbing against internal components. Make sure the rod is straight and mounted properly in the bracket, spinning freely away from other components. Replace it if necessary. Alternatively, the flicker motor may be defective and need replacement.
Why is my Dimplex Indoor Fireplace log set not glowing/pulsing?
If the log set in your Dimplex Indoor Fireplace is not glowing or pulsing, first, check the wiring connections to ensure they are secure. If the wiring is intact, the LED Driver Board may be defective and need replacement. Alternatively, the log set itself may be defective and require replacement.
Why is there light leaking around the log set in my Dimplex BF33ST/DX Indoor Fireplace?
If you notice light leaking around the log set in your Dimplex Indoor Fireplace, it's likely because the log set is not positioned properly. Check the log set for a proper fit and adjust its position as needed.
Why is my Dimplex BF33ST/DX Indoor Fireplace flame not bright?
If the flame in your Dimplex Indoor Fireplace is not bright or not visible, it could be due to burnt light bulbs, which you should replace. Also, check the wiring connections for any looseness. If the issue persists, the light harness might be defective and need replacement.
Why does my Dimplex BF33ST/DX heater emit an odor?
A Dimplex Indoor Fireplace heater may emit an odor for a brief period after being initially turned on, which is normal. This occurs as the heater burns off any dust accumulated during manufacturing or operation. However, if the odor persists, the heater assembly may be defective and require replacement.
General| Model Number | BF33ST/DX |
|---|---|
| Type | Electric Fireplace |
| Power | 2000 W |
| Voltage | 220-240 V |
| Flame Effect | Yes |
| Remote Control | Yes |
| Heater | Yes |
| Thermostat | Yes |
| Timer | Yes |
| Color | Black |
| Heat Output | 2kW |
To Next Page