12
BF5000NT, BF5000, EF2604, SF2603, DF2603
If the fireplace was operating prior to servicing allow at least 10 minutes for light bulbs
and heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE FLAME MOTOR/FLAME ROD
18. Secure new flicker motor to the existing reflector rod. Ensure the flicker motor
bracket is in between the motor and reflector rod.
19. Pick up wire connector and place (1) yellow wire into each terminal.
(total of 2 yellow wires)
20. Secure wire connector by crimping the 3M symbol with slip joint pliers.
21. Pull on end of wires to ensure a strong connection.
22. Repeat the process for the (4) remaining wires. (red, blue, orange, grey)
ENSURE THAT ALL CONNECTORS HAVE THE SAME WIRE COLOURS
23. Reassemble in the reverse order.
To Next Page
Loading...
Need help?
General
