Why is my Dimplex Indoor Fireplace heater fan on but there is no heat?
If the heater fan in your Dimplex Indoor Fireplace is running but not producing heat, there may be loose wiring, which requires tracing the wiring in the unit. It could also be a defective thermostat or heater assembly, both of which would need to be replaced.
Why does my Dimplex Indoor Fireplace trip the circuit breaker?
Your Dimplex Indoor Fireplace might be tripping the circuit breaker due to a short in the unit wiring, which requires tracing the wiring. Alternatively, the circuit's current rating may be insufficient because additional appliances are drawing too much power. Try plugging the unit into another outlet or installing it on a dedicated 15 amp circuit.
Why are lights dimming in the room when my Dimplex DF2608 is on?
If the lights dim in the room when your Dimplex Indoor Fireplace is on, it's likely that the unit is drawing close to the circuit's current rating. Try moving the unit to another outlet or installing it on a dedicated 15 amp circuit.
Why is my Dimplex DF2608 heater turning off after a few minutes?
If your Dimplex Indoor Fireplace heater turns off after a couple of minutes, it may be due to a buildup of dirt or dust in the heater assembly. Make sure the exterior intake louvers and firebox cavity are free of dirt and dust. If the problem continues, the heater assembly may be defective and require replacement.
Why is my Dimplex DF2608 flame not bright or not visible?
A dim or invisible flame in your Dimplex Indoor Fireplace could be due to burnt-out light bulbs, which need replacement. It could also be caused by loose wiring, so check the wiring connections. A defective light harness might also be the culprit, requiring its replacement.
Why is the power cord getting warm on my Dimplex Indoor Fireplace?
A slightly warm power cord during heater operation is normal for your Dimplex Indoor Fireplace. However, if the cord becomes hot to the touch, it may be defective and should be replaced.
What to do if my Dimplex Indoor Fireplace is turning on and off by itself?
If your Dimplex Indoor Fireplace is turning on and off by itself, it could be due to several reasons: * The remote control having a similar frequency to other remotes in the area. * Radio frequency disturbance from outside sources. * A defective remote control receiver. In any of these cases replace Remote Control or Remote Control Receiver and initialize to Remote Control Receiver.
How to fix excessive noise with the heater on in my Dimplex Indoor Fireplace?
Excessive noise with the heater on in your Dimplex Indoor Fireplace can be caused by a dirty heater assembly. Ensure that the exterior intake louvers and firebox cavity are free of dirt and dust. If the noise persists, the heater assembly may be defective and require replacement.
What to do if my Dimplex Indoor Fireplace heater is not turning on?
If the heater on your Dimplex Indoor Fireplace isn't turning on, the issue could be due to loose wiring, which requires tracing the wiring in the unit. Alternatively, a defective heater switch, thermostat, or heater assembly could be the cause, and each of these components may need to be replaced.
What to do if my Dimplex DF2608 is not turning on?
If your Dimplex Indoor Fireplace isn't turning on manually, first check the fuse/breaker panel to ensure there's incoming power from the electrical wall socket. If power is available, the issue might be a defective 3-Position Switch, which would need replacement.
Instructions for installing the fireplace in a new wall opening.
Procedures for installing the fireplace into an existing fireplace structure.
Explanation of the physical controls located on the fireplace unit.
Instructions for using the integrated remote control for the fireplace.
Step-by-step guide for replacing the fireplace light bulbs.
Instructions for cleaning the fireplace glass and exterior surfaces.
General| Type | Built-in fireplace |
|---|---|
| Flueless | Yes |
| Fuel type | Electric |
| Orientation | Vertical |
| Heating power | 1440 W |
| Product color | Black |
| Fireplace type | Closed |
Weight and Dimensions| Depth | 224 mm |
|---|---|
| Width | 695 mm |
| Height | 597 mm |
To Next Page
