18
DS5598, DS5603, DS5804
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.
TO REPLACE HEATER THERMOSTAT CONTROL
1. Remove the stove pipe kit (if equipped).
2. With front door closed, gently place stove door side down on a flat surface.
3. Remove the retaining screws on the REAR stove legs with a screwdriver and
remove the rear legs.
4. Remove the rear cover retaining screw located at the lower center of the rear cover.
5. Slide the rear cover down 4 to 6 inches and gently pull the cover up from both the
top and bottom bowing it slightly and remove it from its mounting slot. When the
cover is removed place beside the stove being careful not to damage any of the
wiring.
6. Locate the heater thermostat control mounted on the rear cover and disconnect the
wiring clips and connections noting their original locations.
7. Pull off the thermostat control knob to expose the mounting screws.
8. Remove the mounting screws and remove the heater thermostat control switch.
9. Properly orientate the new heater thermostat control and connect all of the wiring
clips and connections.
10. Reassemble in the reverse order as above.
To Next Page
Loading...
Need help?
General