9
Assembling the indoor unit
Installation instructions
Bends in the refrigerant pipes may not be positioned
immediately before or after refrigerant couplings!
If it does not matter whether the pipes are visible in the
room, they can be led out of the side of the indoor unit to
the left and routed through the wall at some other suitable
location.
Perforated sections are provided accordingly in the housing
area of the indoor unit.
Drilling through the wall
One opening in the wall with a minimum diameter of 80
mm is necessary for the passage of the condensation hose
as well as the refrigerant and electrical lines from the indoor
unit to the outdoor unit.
The opening must slope downward at an angle of about 5°
toward the outside wall to allow the condensate to drain.
Insert a bushing into the wall opening to prevent damage to
the lines!
The end of the condensate hose may not be stand in the
water.
The diagram below shows the recommended position for the wall opening depending on the minimum distances.
Ø=80
150 150
150
2000
80
60
Front view
B
KSS 2508 KSS 3508 KSS 4508
Maß A
Maß B
770
250
830
285
1020
310
Installation
- The mounting plate for the indoor unit must be aligned horizontally and mounted while observing the minimum clearances.
- Route the lines through the wall opening.
- Engage the indoor unit in the upper profiles of the mounting plate and swivel it downward
until the indoor unit engages.
Indoor unit
To Next Page
Loading...
