Beijing Dingtek Technology Corp., Ltd. Tel:86-10-64718863, 64753700
http://www.dingtek.com E-mail: service@dingtek.com
Room A209, Flounder Business Park, Shunbai Road 12, Chaoyang District, Beijing, China 100022 Page
15
Make sure the position of the jumper cap is switched to the hollow position. If it is
placed at solid position module configuration cannot be completed.
Check if TTL and device RX, TX connection is correct, if the connection is wrong,
there will be no reply sending instructions.
Confirm the baud rate is the correct choice of baud rate, the correct should be
115200.
5.4 Video link
Configuration of Lora parameter DF702 Smart Trash Bin Sensor is shown with detailed you
can follow these instructions as well as click at video link .
https://youtu.be/nklTd88SPXI
6 Configurations of Relevant Parameters of Device
Through the configuration, you can also modify the relevant parameters of the device such
as alarm height value, temperature value, battery level and etc.
6.1 Required tools
Figure6.1
To Next Page
Loading...
Need help?
General