Dingtek DF702 - User Manual

Need help?

Do you have a question about the Dingtek DF702 and is the answer not in the manual?

Dingtek DF702 Specifications

General

Brand	Dingtek
Model	DF702
Category	Control Unit
Language	English

Summary

5 Configure LoRa Parameters

5.1 Required Tools for Configuration

Lists necessary tools for configuring LoRa devices.

5.2 Connect TTL to Sensor

Steps for TTL Connection

5.3 Device Configuration Environment

5.3.2 Serial Configuration Selection

5.3.3 Sending Configuration Commands

Reference Instruction for LoRa Parameters

Set DEVADDR Parameter

How to set the device address parameter.

Set DEVEUI Parameter

How to set the device EUI parameter.

Set NWKSKEY Parameter

How to set the network session key.

Set APPSKEY Parameter

How to set the application session key.

6 Configure Device Parameters

6.1 Required Tools for Parameter Configuration

Lists tools needed for configuring device parameters.

6.2 Connect TTL to Sensor

Steps for TTL Connection (6.2)

6.3 Use Serial Software for Configuration

7 Upgrade Devices

7.1 Upgrade Instructions

7.2 Tools for Upgrading

7.3 Connect TTL to Sensor for Upgrade

Steps for TTL Connection (7.3)

7.4 Device Upgrade Steps

7.4.1 Upgrade Steps

7.4.2 Upgrade Step

7.4.3 Restart Device After Upgrade

7.4.4 Handling Upgrade Output

7.4.5 Hyperterm Preparation

7.4.6 Open Hyperterm Software

7.4.7 Click Connection Option in Hyperterm

Send Upgrade File via Hyperterm

7.4.8 File Transfer and Completion

Notes on Upgrade Verification

2 Common Problems and Solutions

How to Configure LoRaWAN Gateway

Troubleshooting: No Device Data Visible

Troubleshooting: Sensor-Gateway Distance Issues

Troubleshooting: Garbled Data Reception

Troubleshooting: Inaccurate Height Measurement

Device Fall Functionality

Change Device Data Interval