Directed Electronics 554R User Manual

3. The LED will ligh constant when the tach signal is learned.
4. Release the Valet/program switch.
NOTE: A dim or pulsing LED when learning tach means the unit has not learned the tach signal.
Test all connections, and if good, relocate the tach input wire and continue with tach learning
procedure.
Shutdown Diagnostics
The unit has the ability to report the cause of the last shutdown of the remote start system.
TToo eenntteerr ddiiaaggnnoossttiicc mmooddee::
1. Turn the ignition off.
2. Press and hold the Valet/program switch.
3. Turn the ignition on then off again.
4. Release the Valet/program switch.
5. Press and release the Valet/program switch.
The LED will now report the last system shutdown by flashing for one minute in the below grouped
patterns; the LED will stop flashing when the ignition is turned on.
34
©
2002 Directed Electronics, Inc.

Directed Electronics 554R Specifications

General

Brand	Directed Electronics
Model	554R
Category	Security System
Language	English