36
©
2003
Directed Electronics, Inc.
24-Hour Timer Mode
To enter 24-hour Timer Mode, press and simultaneously. The remote control will produce
a melody and the clock indicator will appear on the remote’s LCD. Once in Timer Mode, the
system will remote start every 24 hours. Repeat this process to turn Timer Mode off.
Diagnostics
The system’s microprocessor monitors and reports all active and violated zones when arming and
disarming. LED flashes indicate the active or violated zone; siren chirps indicate system status.
Arm/Disarm Diagnostics
The number of siren chirps will indicate the status of the system when arming and disarming. For
information on which zone is active or has been violated refer to the Table of Zones.
System Status Chirps
Table of Zones
NOTE: The Warn Away® response does not report on the LED.
Zone DESCRIPTION LCD Icon
(LED Flashes)
1 Instant trigger - hood pinswitch Hood Open and Trigger Alert Icon
2 Instant trigger - a heavier impact Full Trigger Shock Sensor Icon
detected by the shock sensor
3 Door switch trigger Door Open and Trigger Alert Icon
4 Instant trigger - for optional sensors N/A
5 Ignition trigger N/A
Action Number of Chirps Description
Arm 1 System armed
Arm 1 (3 second delay), 1 System armed with Bypass Notification
Disarm 2 System disarmed
Disarm 4 System disarmed with Tamper Alert
Disarm 5 System disarmed NPC® active
To Next Page
Loading...
Need help?
General
