17
© 2005 directed electronics, inc.
QQUUIICCKK RREEFFEERREENNCCEE GGUUIIDDEE::
TToo aarrmm tthhee ssyysstteemm
■ You can arm the system by locking the doors with your factory keyless
entry transmitter. When the system arms, your will hear a short horn
honk, and see the parking lights flash once.
TToo ddiissaarrmm tthhee ssyysstteemm
■ To disarm the system, unlock the doors using your factory keyless trans-
mitter. You will hear two horn honks, and the parking lights will flash
twice.
DDiissaarrmmiinngg wwiitthhoouutt aa ttrraannssmmiitttteerr
■ Turn on the ignition. Press the integrated LED/Valet® switch the pro-
grammed number of times within 10 seconds. The system should now
disarm. If it does not, you may have waited too long. Turn the ignition
off and on and try again.
TToo eenntteerr oorr eexxiitt VVaalleett
®®
MMooddee
■ Turn ignition to “run” position, then turn to “off” position. Press and
release the integrated LED/Valet®switch within 10 seconds. The status
LED will light solid if you are entering Valet® Mode, and it will go out if
you are exiting Valet® Mode.
RReemmoottee VVaalleett
®®
■ Open any door. Press the lock button on your transmitter. Within one
second, press the unlock button on your transmitter. Within one second,
press the lock button on your transmitter again. The status LED will stay
on if you have entered Valet® Mode, and it will go out when exiting
Valet® Mode.
CCuutt aalloonngg ddootttteedd lliinnee aanndd ffoolldd ffoorr aa qquuiicckk aanndd eeaassyy rreeffeerreennccee ttoo kkeeeepp iinn yyoouurr ppuurrssee oorr wwaalllleett..
✂✂
✂✂
To Next Page
Loading...
Need help?
General
