To Next PageTo Next Page
Need help?Do you have a question about the Directed Electronics Python 533 and is the answer not in the manual?
General| Brand | Directed Electronics |
|---|---|
| Model | Python 533 |
| Category | Car Alarm |
| Language | English |
Default RPM-sensing method using voltage sensing for keyless entry/remote start systems.
System interface with Xpresskit module via D2D port for reduced wiring.
Location and importance of the valet/program switch for system control and disarming.
Guidelines for positioning the Status LED for visibility and accessibility.
Details and connections for the 12-pin primary harness.
Details and connections for the 6-pin auxiliary harness.
Details and connections for the 3-pin door lock harness.
Wiring for the 7-pin remote start ribbon harness.
Connections for the heavy gauge relay satellite.
Wiring for the 4-pin relay satellite connector.
Details and connections for the 5-pin remote start harness.
Connections for the 2-pin AUX 4/Horn harness.
Step-by-step procedure to test the neutral safety switch functionality.
Instructions for programming Virtual Tach mode for engine RPM sensing.
Procedure to teach the system the tach signal for accurate RPM sensing.
Setting the jumper to adjust tach signal trigger threshold for certain vehicles.
Jumper setting to determine parking light flash output polarity.
Default button assignments for remote control functions like Arm, Lock, Remote Start.
Detailed explanation of basic system features.
Detailed explanation of advanced system features.
Detailed explanation of remote start specific features.
Troubleshooting common alarm system issues and sensor problems.
Troubleshooting common remote start activation and operation issues.
