55
© 2009 Directed Electronics. All rights reserved.
Long term event history
The system stores the last two full triggers in memory. These are not erasable.
Each time the unit sees a full trigger, the older of the two triggers in memory will
be replaced by the new trigger. To access long term event history:
1. With the ignition off, press and hold the Valet/Program
switch.
2. Turn on the ignition.
3. Release the Valet/Program switch.
4. Press and release the Valet/Program switch within 5 sec-
onds. The LED will flash in groups indicating the last two zones
that triggered the unit. The LED will flash for one minute or until
the ignition is turned off.
NOTE: The Warning Zone triggers are not stored to memory and will not be
reported.
To Next Page
Loading...
