Directed Electronics DMHD-1000 - Installation Notes and Defaults

© 2006 Directed Electronics, all rights reserved
8
Installation Notes:
Initial Power-up defaults
1. Source defaults to FM
2. Frequency :
Preferred initial behavior : Tuner starts at 87.9 MHz
(Currently "Mhz" or "Khz" does not appear on the UI)
The bank number to store frequency is set to 1.
Loss of signal strength while playing HD
a. If stream does not resume within 10 sec,
Switches to analog signal (does not mute even if analog signal is
poor).
Flashes the "Blinking HD logo" screen overlay for 10 seconds.
Removes HD logo and updates display to analog signal type.
b. If stream resume within 10 sec,
Maintains previous SPS channel and display mode.
Discontinued supplementary channel while playing HD
If an HD supplementary channel is discontinued while the unit is tuned to it,
1. Mutes audio when stream is no longer available.
2. Shows "NOT AVAILABLE" screen overlay for 5 seconds. And jump to main
channel.