Need help?Do you have a question about the Directed Electronics DMHD-1000 and is the answer not in the manual?
General| Brand | Directed Electronics |
|---|---|
| Model | DMHD-1000 |
| Category | Car Receiver |
| Language | English |
Instructions for physically mounting the unit, considering ventilation and interference.
Details the yellow wire (+12 volt constant) on the 4-pin connector for power.
Explains Red (+12V switched), Black (Ground) wire connections for power and ground.
Details antenna inputs/outputs, RCA audio outputs, and display interface.
Covers power-up defaults, signal loss handling, and supplementary channel behavior.
Overview of the Commander unit's buttons and their functions.
Explains the remote control and its identical button functions to the commander.
Covers power on/off and introduces the four radio modes.
Details button operations, seek modes, presets, bank selection, and navigation.
Explains the different display modes for Analog Radio.
Explains HD display modes 1, 2, and 3.
Details control operations in HD Radio Mode.
Describes RDS display modes 1 and 2.
Details RDS operation controls including BANK, NAVIGATION, and MENU.
How to enter, navigate, and exit Setup Mode menus using the MENU button.
Details LCD settings (contrast, brightness) and RF modulation options.
Lists voltage, temperature, current draw, and fuse size.
Details FM/AM tuning range, sensitivity, rejection, and bandwidth.
Provides input frequency, IF bandwidth, and impedance information.
To Next Page