36
© 2010 Directed Electronics. All rights reserved.
While the vehicle is running during remote start operation, the system monitors the ve hi cle and automatically
shuts down the engine if it receives any of the following shut-down inputs:
• The brake pedal is pressed.
• The hood is opened.
• The shutdown toggle switch is put into the Off position.
• The pre-programmed run time (12, 24, or 60 minutes) has elapsed.
• Remote control button
is pressed once.
Valet Take-Over
The Valet Take-Over feature allows the vehicle to remain running after the key has been removed from the
ignition. This feature is useful for occasions when you wish to exit and lock the vehicle for short periods of
time, but would like to leave the engine running and the climate controls on.
To perform Valet Take-Over:
Before turning off the engine, press and release on the remote control for 1 second.
Turn the ignition key to the Off position. The engine will stay running until the pre- pro gram med time has
elapsed or a shutdown input is received. (See the previous Remote Start section for a complete list of shut-
down inputs.)
Important: This feature will not work if the brake pedal is being pressed.
To Next Page
Loading...
Need help?
General
