35
© 2010 Directed Electronics. All rights reserved.
Using the System
Note: Horn function is an programmable feature, it is Off by default. See Feature Menus and Programming
System Features to turn on.
Locking
Pressing for one second locks the system (if the door locks are connected). The horn honks (see note) and
the parking lights flash once to confirm the system is locked.
Unlocking
Pressing for one second unlocks the doors (if connected). The horn honks twice and the parking lights
flash twice to confirm unlocking of the system.
Panic Mode
If you are threatened in or near your vehicle, you can attract attention by trig ger ing the system with your
remote control. Press and hold for 2 seconds to enter Panic Mode. In Panic Mode, the horn will honk and
the parking lights will flash for 30 seconds. To stop Panic Mode at any time, press
, or on the remote
control.
Note:
In order for Panic Mode to be effective, the vehicle’s horn (or optional siren) and the vehicle's parking
lights must be connected.
Remote Start
This feature allows you to remotely start and run your vehicle for a pro gram ma ble period of time. This makes
it possible to warm up the engine, and adjust the interior tem per a ture of the ve hi cle with the climate control
system. If interior heating or cooling is desired, the climate controls must be preset, and the fan blower must
be set to the desired level prior to remote starting the vehicle.
Warning!
(1) Never remote start your vehicle when the keys are in the
ignition, except when performing Valet Take-Over, and (2) Never start
the vehicle if it is not in PARK or NEUTRAL
To remote start the vehicle:
•
Press
the button once (default)*.
• The parking lights flash to confirm that the vehicle is attempting to start. In gasoline vehicles the engine
will start 4 seconds after the parking lights flash, in diesel vehicles the engine starts after the Wait-To-Start
timer has expired (default is Off)*.
• Once the vehicle has started, it will run for 12 minutes (default)*, or until a shutdown input is trig gered.
*
Defaults:
Remote Start Activation Pulse Count (button presses), Wait-To-Start timer and Engine Runtime can
be changed, see corresponding features in Feature Menus and Programming System Features.
Warning!
It is unsafe to operate a vehicle’s motor in a garage or other
closed off area. Breathing the ex haust from the vehicle is hazardous to
your health. Never activate the remote start in an enclosed space.
When you are ready to drive the vehicle:
1.
Insert
the ignition key and
turn
it to the On (not the START) po sition.
2.
Press
the brake pedal. The remote start system shuts down and the engine continues to run because the
ignition has been turned on.
Note:
If the brake pedal is pressed before the key is in the On position, the engine will shut down.
To Next Page
Loading...
Need help?
General
